DeFelsko PosiTector UTG v.3.1 Full Manual - Manual (Page 4)

1
Introduction Introduction
The PosiTector UTG is a hand-held Ultrasonic Thickness Gage
that uses the non-destructive ultrasonic pulse-echo principle to
measure the wall thickness of a wide variety of materials. It
consists of a body (Standard or Advanced) and probe (UTG C or
UTG M, see pg. 4).
The PosiTector UTG powers-up when the center navigation
button is pressed. To preserve battery life, the instrument
powers down after approximately 5 minutes of no activity. All
settings are retained.
1. Remove the protective rubber cap from the probe.
2. Power-up Gage by pressing the center navigation button.
3. Zero the probe (see pg. 10)
4. Select the correct velocity of sound (see pg. 11)
5. Measure the part (see pg. 6)
Quick Start Quick Start
PosiTector UTG Kit Contents
- PosiTector body (Standard or Advanced)
- PosiTector probe (UTG C or UTG M)
- Protective rubber cap for Probe
- Protective lens shield
- Wrist strap
- 3 AAA alkaline batteries
- Quick Guide instruction booklet
- Protective rubber holster
- Nylon carrying case with shoulder strap
- Belt clip for rubber holster and carrying case
- USB Cable
- 4 ounce (118 ml) bottle ultrasonic couplant
- Certificate of Calibration traceable to NIST
- PosiSoft.net account
- Two (2) year warranty on Body and Probe