DeFelsko PosiTector UTG v.3.1 Full Manual User Manual
Page 28
25
Summaries
(Advanced models only)
Displays a summary of all stored
batches including the name, probe
type, number of readings and type.
In the following example, Batch 3
(B3) indicates an “F” 6000 coating
thickness probe was used to record a
total of “6” readings in “PA2” mode.
Remove the last reading from the current open batch by
pressing (-).
Calibration adjustments cannot be made if any measurements
were taken with that Cal setting and stored into a batch.
Each batch can contain a maximum of 10,000 readings.
NOTES:
S c r e e n C a p t u r e
Press both (-)(+) buttons at any time to capture and save an
image copy of the current display. The last 10 screen captures
are stored in memory and can be accessed when connected to
a computer (see PosiSoft USB Drive pg. 29).
Sample Screen Captures