DeFelsko PosiTector UTG v.3.1 Full Manual - Manual (Page 22)

19
HiLo Alarm
ü
Allows the Gage to visibly and audibly alert the user when
measurements exceed user-specified limits.
When HiLo Alarm is selected, the current Lo setting is displayed.
Adjust down (-) or up (+). Alternatively, measure a material with a
thickness close to the required value and make final adjustments
with the buttons. Select NEXT to accept this value. The current Hi
setting is now displayed. Follow the same procedure to adjust the
Hi setting.
The icon will appear on the display.
Measurements will be compared to your defined HiLo limits. The
Gage beeps if results are within those limits. A single low tone will
sound if the reading is below the Lo limit, and a high tone if it is
above the Hi limit. Press (+) to clear HiLo readings.
Statistics Mode Statistics Mode
A statistical summary will appear on the display. Remove the last
measurement by pressing the (-) button. Press (+) to clear
statistics.
Statistics
ü
x
Mean
(average)
Standard
Deviation
# of
measurements
Minimum
measurement
Last
reading
Maximum
measurement
x
Statistics
Icon
mm
Converts displayed and printed words to the selected language.
Language
Clear
Clears all onscreen Statistics and HiLo tabulations.