Run mode screens, L1 l2, Rt-30ex flow transmitter – AW Gear Meters RT-30EX User Manual
Page 13: Rate

RT-30EX Flow Transmitter
Operation and Programming Manual
13
RT-30EX User Manual, Rev. 1.7 02/07/2012
RT-30
S/N 0000000
Software Version 1.1.3
HART SW version 1.1.0
RATE
100.00
GPM
LN GT
TOTAL
249.00
GAL
GRAND TOTAL
12345.67
GAL
RT 12345.67
GPM
TO 12345.67
GAL
LN GT
STATUS
L1 OFF : L2 OFF
RA 2345.67 HZ
TO 1234567 PUL
ANLG 20.00mA
ANALOG OUT
XX
20.00 mA
LN GT
UP/DN
UP/DN
UP/DN
UP/DN
UP/DN
UP/DN
UP/DN
DN
Rate
ON/OFF
Total
ON/OFF
L1
L2
UP
Run Mode Screens
The run mode screens, as shown below, can be accessed by using the
UP
and
DN
buttons or using the
attached magnet wand to activate internal hall switches.
Logo screen shows critical information on RT-30EX firmware version
RATE screen shows active flow rate information in programmed
engineering units
TOTAL screen shows totalized volume in programmed engineering
units
RT/TO screen shows both the flow rate and total values in
programmed engineering units
GRAND TOTAL screen shows totalized volume in programmed
engineering units and is not affected if TOTAL is reset.
STATUS screen shows data summary. Flow and total are in un-scaled
units of Hertz for flow and Pulses for total.
ANALOG OUT screen shows the mA value the RT-30EX is outputting.
L1/L2 screen shows information for Limit outputs.
Figure 9: Run Mode screens - overview