AST AST2000H2 Datasheet - Manual (Page 2)

Workmanship - AST, Inc. pressure transmitters have a limited one-year warranty to the original purchaser. AST, Inc. will replace or repair,
free of charge, any defective transmitter. This warranty does not apply to any units that have been modified; misused, neglected or installed
where the application exceeds published ratings. AST’s sensors are made with pride in New Jersey, USA. If in the area please feel free to
stop by for a visit!
Installation/Applications - The purchaser is responsible for media compatibility, functional adequacy, and correct installation of the transmitter.
TM
www.astsensors.com © 2012 American Sensor Technologies Inc. AST2000-H2 12/18/12.
All specifications subject to change without notice.
Warranty
Dimensional Data
Ordering Information
Series
Pressure Ports
F= 7/16-20 UNF Male [SAE 4]
M= 3/8-24 UNF Male [SAE 3]
X= Special (see option code 487)
Pressure Range
+
00020= 20 Bar
00448= 448 Bar
00500= 500 Bar
00700= 700 Bar
00900= 900 Bar
Pressure Unit
B= Bar
Output
1 = 0.5-4.5V ratiometric [5VDC supply]
Electrical
F= Packard Metripack 150
Wetted Material
1= 316L
Options
000= No Options
384= High Accuracy
487= 1/2-20 UNF Stud for high pressure H
2
storage
AST2000 F 00500 B 1 F 1 000 Test Performed
The tests preformed are marked as "X" in the following table. The test
conditions, parameters, and details are described in the Annex 1. (Test
Report) to Technical Report No. KS1011296 dated 2011-01-04.
No. Type of Test EU 406/2010
Annex IV
Remark
1 General Requirements Part 3 Sect. 2 X
2 Technical
Requirements
Part 3 Sect. 3 X
3 Hydrogen
Compatibility Test
Part 3 Sect. 4.1.1 X
4 Ageing Test* Part 3 Sect. 4.1.2 X
5 Ozone Compatibility
Test**
Part 3 Sect. 4.1.3 Not
Applicable
6 Corrosion Resistance
Test
Part 3 Sect. 4.2.1 X
7 Endurance Test Part 3 Sect. 4.2.2 X
8 Hydraulic Pressure
Cycle Test
Part 3 Sect. 4.2.3 X
9 Internal Leakage Test Part 3 Sect. 4.2.4 Not
Applicable
10 External Leakage Test Part 3 Sect. 4.2.5 X
11 Isolation Resistance
Testing
ECE R110 Rev. 1 X
12 EMC Compatibility
Testing
ECE R110 Rev. 1 X
13 Review of Information
Documentation
EU 406/2010 Annex
II Part 1
X
* Test applies only for non-metallic materials ** Test applies only to elastomer
materials where either a sealing surface is exposed directly to air or if used as a
flexible fuel line cover.
+ 3/8-24 UNF Male [SAE 3] is only available for 20 bar and 448 bar