Triton RL5000 X2 Series Installation Manual - Manual (Page 38)

3 8
M
ODEL
RL5000 (X2) I
NSTALLATION
G
UIDE
The Ethernet option makes your RL5000 ATM LAN (Local Area Network) or WAN (Wide Area Network)
capable. The ATM functions that are normally performed via the dial-up telephone system, such as
customer transactions and remote monitoring, can now be performed using existing in-house communica-
tions network. ATM transaction processing and hardware monitoring functions are performed across a
shared network medium. Ethernet is popular because it strikes a good balance between speed, cost and
ease of installation. These benefits, combined with wide acceptance in the computer marketplace and the
ability to support virtually all popular network protocols, make the Ethernet option an ideal networking
solution for your RL5000 ATM.
TCP/IP C
ABLE
(CAT-5) C
ONNECTIVITY
1. If the unit is ON, enter M
ANAGEMENT
F
UNCTIONS
> S
YSTEM
P
ARAMETERS
> S
HUT
D
OWN THE
T
ERMINAL
.
When prompted on the screen, open the control panel hood and turn the power switch on the power
supply to the OFF (0) position.
2. Refer to the section on “Power and Communication”. Route the 10Base-T (CAT-5) cable through the
cabinet base cable access hole. Secure cable inside vault area and continue up to the control panel
access holes.
3. Connect the RJ-45 end of CAT-5 cable to the TCP/IP connector located on the X2 M
AIN
B
OARD
assembly as shown in figure below.
4. Secure cable into existing cable harness runs. Refer to the Configuration manual for programming
Ethernet options.
USB P
ORTS
RJ-45 (CAT-5)
TCP/IP P
ORT
TCP/IP (E
THERNET
)