Triton RL5000 X2 Series Installation Manual - Manual (Page 34)

3 4
M
ODEL
RL5000 (X2) I
NSTALLATION
G
UIDE
b. Select Diagnostics from the Management
Functions screen, then Dispenser.
c. Select the Test Dispense option. Select cassette
“A”. A prompt appears asking how many notes
to dispense. (Figure 5) The Test Dispense
operation will start.
d. The Test Dispense command instructs the
dispenser to dispense, minimum, one note from
the the note Cassette into the reject tray of the
cassette. This test exercises the dispenser without
sending notes to the exit.
e. After completion of the Test Dispense operation,
the following prompt is displayed - “Test Dispense
Completed Successfully - Dispense Count, A: (#
of notes)”.
(Figure 6)
Figure 5. Enter # of notes.
Figure 6. Test dispense prompt.
10. Install currency in the cassette and insert into
the dispensing mechanism. Refer to Section 4,
Cash Replenishment, in the RL5000 User manual
for detailed information about handling cassettes.
**CAUTION**
Make sure the cassette is primed
and the window below the lock
displays green before installing
the cassette. Attempting to install
an unprimed cassette into a
dispensing mechanism may
damage the cassette and void its
warranty.
11. Open the control panel and apply AC power to the
ATM by pushing the AC power switch to the ON
(1) position.
12. Complete the ATM setup, if necessary, according
to the instructions in the RL5000 Configuration
manual or applicable Service manual.
13. Follow the remaining steps to perform a Test
Dispense:
a. Access the Management Functions
main menu screen. Refer to RL5000
User Manual for instructions on
accessing the Management
Functions main menu.
DO NOT PROCEDE WITH STEP 10
UNTIL THE INSTALLATION
IS COMPLETE