Star Water Systems S1101 - Manual (Page 13)

13
Water
Supply
5 in. Min.
1-1/2 in. Min.
7 in. Min.
7 in. Min.
2 in. Min.
6 in. Min.
Do not drill in
Cross-hatched areas
of tank
Center line point
for 3 in. hole saw.
Cut Template
Along This Line.
3 in. Dia.
5
5. Connect water line to toilet, fill tank and test pump
system.
INSTALLATION OF TOILET - HIDDEN INSTALLATION
1
1. A 3 in. hole must be drilled into pump system in order to
add additional fixtures. The hole can only be drilled in
the areas shown.
CAUTION: Do not drill in cross-hatched areas noted.
NOTE: Use only with additional fixtures normally found
in a typical bathroom. Not recommended for washing
machines, dishwashers or other equipment.
2
2. Attach the spotting template from page 19 to the
desired location on pump system and center the punch
hole as shown on the template.
NOTE: Pump system is preassembled with pump
inside tank. Use caution when drilling into tank. Be sure
to remove any drilled plastic material from tank when
drilling is complete.
INSTALLATION OF ADDITIONAL FIXTURES