LT Security LTD2432MD - Manual (Page 20)

DVR User Manual
14
3
Basic Function Instruction
3.1 Power On/Off
Before you power on the unit, please make sure all the connection is good.
3.1.1 Power on
Step1: connect with the source power; then switch on the power button near the power port on the rear panel.
Step2: the device will be loaded, and the power indicator will display blue.
Step3 before start, a WIZZARD window will be pop-up and show some information about time zone，time setup，network
configuration, record configuration and disk management. User can setup here and refer to the concrete setup steps from the
corresponding chapters. If users don’t want to setup Wizard, please click Exit button to exit.
If there is no menu or only has live image display after the device is power on, user can long press EXIT button to switch.
Notice: this serial device can only display options on either VGA monitor or BNC monitor at one time, if there is live image display
without menu options, please check if there is display on other device/monitor, or long press EXIT key to wait for login dialog box
to appear. Long press EXIT key can switch the output between BNC and VGA.
3.1.2 Power off
User can power off the device by using remote controller、keyboard and mouse.
By remote controller:
Step1: press Power button to display the Shut down window. Click OK and then the unit will power off after a while.
Step2: disconnect the power.
By keyboard and mouse:
Step1: enter into
Menu  select “Shut Down” icon. Then the Shut down window will appear.
Step2: after clicking OK, the unit will power off after a while.
Step3: disconnect the power.