Lincoln Electric IM840 ETHERNET_DEVICENET MODULE K2436-1 - Manual (Page 9)

Locate the Communication Interface Module decal on
the top door assembly. Remove the portin reads
“optional” apply the Ethernet / DeviceNet decal as
shown in the DECAL MOUNTING detail below.
Remove the screws in the door assembly. Lower door
as shown in Figure A-1. Do not lean against the door
assembly during installation, hinge damage may occur.
ETHERNET/DEVICENET MODULE SETUP
This guide covers the setup and installation of the
EtherNet/DeviceNet module.
• The setup and installation of the module.
• The installation of the software on a PC.
• The serial connection between the Power Wave and
the PC (for intial setup only).
• How to connect the Power Wave to an Ethernet net-
work.
• How to configure the Power Wave to communicate
over an Ethernet network.
POWER WAVE SETUP
• ELECTRIC SHOCK CAN KILL.
• Do not touch electrically live part
or electrode with skin or wet cloth-
ing.
• Insulate yourself from work and
ground.
• Disconnect the input power from
the Power Wave.
------------------------------------------------------------------------
Locate the hardware bags and review their contents.
Some items in the small HARDWARE BAG will not be
used. Some Items in the Large bag may or may not
be used unless a Wire Drive Interface Module is
installed. See the following instructions.
A-2 INSTALLATION
ETHERNET / DEVICENET MODULE
A-2
MODULE INSTALLATION INSTRUCTIONS
Ethernet / DeviceNet Module Quick Start Guide
REQUIRED TOOLS
3/8 Wrench or nut Driver
Short Phillips Screw Driver
OPTIONAL TOOLS
Serial Cable (Radio Shack Cat. Number. 26-269)
Microsoft Windows compatible computer
FIGURE A-1
1
2
3
J16
J73
4-pin to 6-pin
interconnect
DETAIL
RUBBER RING
THIS SIDE
4
5
INSTALL WITH
KEY TO THE
RIGHT SIDE
DO
NUT
LOCKNUTS
NOT
OVERTIGHTEN
Ethernet Bulkhead
Connector
Locknut (6)
Rubber Ring (1)
ITEMS CONTAINED IN THE SMALL HARDWARE BAG
Self-tapping
screw (4)
Plastic LED lens (1)
#10 hardware
(washer, lockwasher, nut)
(1 each)
Fold out, break
and discard.
Ethernet
Decal
DECAL MOUNTING
WARNING
4 pin to 4 pin
connector (1)
CAT5 cable (1)
Ethernet bulkhead
connector (1)
ITEMS CONTAINED IN THE LARGE BAG
4 pin to 6 pin
connector (1)