Lincoln Electric IM840 ETHERNET_DEVICENET MODULE K2436-1 - Manual (Page 17)

From the file menu select Device Net and then select
Monitor. The DeviceNet Monitor will display the status
of the connection and its data. If everything is operat-
ing correctly, the "Polled IO Cnx State" will display
"Established" and the IO Scans/Sec will have a non-
zero value. If there appears that there is no connec-
tion to the Power Wave refer to the trouble shooting
section of this quick start guide.
Consult the DeviceNet Interface Specification
(Y50031-xx_DeviceNetInterfaceSpecification) con-
cerning the proper configuration of the DeviceNet
interface.
When all settings have been verified, close Power
Wave observer.
A-10 INSTALLATION
ETHERNET / DEVICENET MODULE
A-10
From the file menu select Device Net and then
Configuration. The configuration window will open up
and allow you to verify that the set MAC address and
Baud rate are correct.