Hired-Hand Farm Hand Series: POWER VENT INLET - Manual (Page 20)

Part No. 4801-0149 Rev 1-01 Farm Hand Power Vent 18
15. Program Data Sheet
Use this Data Sheet to record your personal settings for the Farm Hand Power Vent. Copy this sheet as needed.
No Ramping:
High Pressure Limit
Low Pressure Limit
Explanation: Parameter Setting
Temperature Unit 1 0= Fah. /1= Cel.
Pressure Parameters P2 0=In.w.c. 1=Mill w.c. 2=Pascals
Time Delay 20 Sec.
Ramping Function:
Ramping On or Off P30 1=On / 0=Off
High Temperature P31
High Temp. - High Pressure P32
High Temp. - Low Pressure P33
Low Temperature P34
Low Temp. - High Pressure P35
Low Temp. - Low Pressure P36
Network:
Network Address P40
Software Version P41
Controller Setup P42
Alarm Function:
Low Pressure Limit P60
High Pressure Limit P61
Cycle Alarm:
Cycle Time P62
Cycle Pressure P63
Sensor Calibration:
Outside Sensor PS1
F F a a r r m m H H a a n n d d P P o o w w e e r r V V e e n n t t