HATZ Diesel 4H50TIC User Manual

Page 40

Procedure

NOTICE

▪ After approx. 20 seconds the start procedure cuts off auto-

matically to protect the starter. If the engine is still not run-
ning after that, turn the starting key back to position "0" and
eliminate the cause (see the chapter 9.1 Fault table,
page 86).

▪ Turn the starting key to position "0" every time you want to

start the engine.

▪ The anti repeat device in the ignition lock makes it impossi-

ble for the starter to engage while the engine is running and
become damaged.

Step

Activity

Remove the protective cap (4) from the ignition lock.

Insert the starting key all the way and turn to position "I".
Depending on the model, the following indicators light up:
▪ Charge control (10)
▪ Oil pressure display (9)
▪ Pre glow display (6)

NOTE: If the optional engine temperature display (8) lights up,
the coolant temperature is impermissibly high. Do not start the
engine; eliminate the cause.
When the optional pre glow display (6) goes out, continue with
step 3.

Turn the starting key to position "II".

As soon as the engine is running, release the starting key.
▪ The starting key springs back to position "I" and remains in

this position during operation.

▪ The charge control (10) and oil pressure display (9) go out.
▪ The operating display (11) lights up.

NOTICE

▪ In case of irregularities, switch off the engine immediately.
▪ Identify the fault and eliminate it.
▪ For details of troubleshooting, see the chapter 9.1 Fault ta-

ble, page 86.

4H50TIC

Operation and use

HATZ

Operator's Manual