Ultra Start 72 Series - Manual (Page 8)

SYSTEM PROGRAMMING - Menu 1
PAGE 8
INSTALL MANUAL
TACH / TACHLESS LEARNING
AUTO TACH/ TACHLESS LEARNING
Horn will chip to confirm that
the Tach/ Tachless has been programmed.
Start the vehicle with
the ignition key.
2 CHIRPS
**
For Vehicles with 12volt START wire**
To Tach/ Tachless Learn the system simply start the vehicle with the ignition key. To
confirm that a proper Tach signal has been programmed the system will chirp the
Horn and flash the Park lights two times. If the Tach wire is not connected the park
lights will flash and the Horn will chirp 4 times to indicate Tachless Mode. If the Tach
is not learned when the start button is pressed the park lights will flash 7 times.
***The system must be Tach Learned before remote starting***
MANUAL TACH/ TACHLESS LEARNING
Start the vehicle with
the ignition key.
SYSTEM PROGRAMMING - Menu 1
**For vehicles with no 12volt START wire**
Many new GM and Chrysler vehicles do not have a 12volt start wire that the remote
start is connected to. Use the following steps to manually Tach learn the system.
Press and Hold the brake pedal, Start the vehicle with the key then place the
transmission into reverse to reduce the RPM. Press and release the program button
then press and hold it for 5 seconds. The Horn will chirp and the lights will flash
two times to confirm that a proper Tach signal has been programmed the system.
If the Tach wire is not connected the park lights will flash and the Horn will chirp 4
times to indicate Tachless Mode. If the Tach is not learned when the start button is
pressed the park lights will flash 7 times.
***The system must be Tach Learned before remote starting***
BRAKE
Hold the
brake
4 CHIRPS
Horn will chip to confirm
that the Tach/ Tachless has been
programmed. 2 CHIRPS
4 CHIRPS
72 SERIES