72 series – Ultra Start 72 Series User Manual

Page 23

SYSTEM PROGRAMMING - Menu 1

PAGE 23

INSTALL MANUAL

TRANSMITTER PROGRAMMING

SYSTEM PROGRAMMING - Menu 1

ENTERING REMOTE PROGRAM MODE

The system can lean up to 4 different remote’s. Each remote to be used MUST
be programmed together during the same sequence. For security, when a new
remote is programmed all previous remote’s are deleted. Please see remote
operation chart for information on using Second Car / Pad Lock Operations.

HOLD the program switch, the HORN will chirp ONCE and the park lights will
turn on. (If the HORN does not chirp repeat step 1) CONTINUE TO HOLD until
the HORN chirps 5 times

Press & Release LOCK button on 1st Remote to be
Programmed for Normal Operation If remote(s) are to be
programmed for "PADLOCK" (AM 1way Only) skip and goto step 6

Press & Release BUTTON 4 on Remote to be Programmed
for 2ND CAR OR PAD LOCK

HORN will Chirp 1 time to confirm remote has been
programmed (If the HORN does not chirp press button again)

PROGRAMMING REMOTE’S

Cycle the Ignition Key - ON/OFF ON/OFF ON
(Leaving the key ON)

Turn ignition key OFF to exit remote program mode when
all required remote’s have been programmed.

1 chirp confirms program mode entered followed by
5 chirps confirming transmitter program mode

1 -

2 -

3 -

4 -

6 -

5 -

7 -

8 -

REPEAT STEP 4 IF A SECOND REMOTE IS TO BE PROGRAMMED FOR NORMAL OPERATION

REPEAT STEP 6 IF A SECOND REMOTE IS TO BE PROGRAMMED FOR 2ND CAR / PADLOCK OPERATION

To program 2nd car operation on 2way models enter transmitter program mode and turn the # icon
on then program the transmitter to the vehicle. If the # icon is on the remote is in 2nd car operation

72 SERIES