Ultra Start 72 Series - Manual (Page 15)

SYSTEM PROGRAMMING - Menu 1
PAGE 15
INSTALL MANUAL PROGRAM MODE
Press Lock Press Unlock Press Start Press #
MENU 1 MENU 2 MENU 3 MENU 4
1 - Cycle the Ignition Key On/Off On/Off On (Leaving the key ON)
2 - Press and release the Program Switch 1 time. (The Park lights will turn on and the Horn
will chip to confirm that program mode was entered)
3 - Select the Program Menu by pressing...
ENTERING PROGRAM MODE
1 - Cycle the Ignition Key On/Off On/Off On (Leaving the key ON)
2 - Press and RELEASE the Program Switch 1 time.
(HORN will chip to confirm that program mode was entered)
3 - Press and HOLD the Program Switch for until the HORN Chirps 3 times.
4 - Turn ignition key OFF to exit.
Note- System reset does not delete the transmitter codes from memory or reset Menu 3 Setting
1 (selectable Output) back to second ignition. This setting must be manually changed.
SYSTEM RESET
4 - Press and Release the Program Switch to advance through the settings.
(Confirmed by HORN chirps & LED flashes)
5 - Press and hold the Program Switch to change the setting.
(Confirmed by HORN Chirps)
6 - To exit Program Mode, turn key off.
(Confirmed by Long HORN Chirp)
SELECT AND CHANGE
72 SERIES