Ultra Start 72 Series - Manual (Page 5)

SYSTEM PROGRAMMING - Menu 1
PAGE 5
INSTALL MANUAL QUICK VIEW PROGRAMMING
Press Lock Press Unlock Press Start Press #
MENU 1 MENU 2 MENU 3 MENU 4
1 - Cycle the Ignition Key On/Off On/Off On (Leaving the key ON)
2 - Press and release the Program Switch located on the antenna 1 time.
*The Horn will chirp and the park light will turn on to confirm that the system
has entered Program Mode.
3 - Select the Program Menu by pressing the button that corresponds to the
desired Program Menu.
ENTERING PROGRAM MODE
1 - Cycle the Ignition Key On/Off On/Off On (Leaving the key ON)
2 - Press and RELEASE the Program Switch 1 time.
(Horn will chip to confirm program mode has been entered)
3 - Press and HOLD the Program Switch for 5 seconds or until the Horn Chirps 3
times.
4 - Turn the ignition key OFF to exit.
4 - Press and Release the Program Switch to advance through the settings.
*The horn will chirp and LEDs flash the same number of times as the selected setting.
5 - Press and hold the Program Switch to change the setting.
(The horn will honk and the park lights will flash to indicate the option selected)
6 - To exit Program Mode, turn the key off.
(Confirmed by Long Horn Chirp)
72 SERIES
SYSTEM RESET