Elitegroup G731 - Manual (Page 84)

1.
2.
3.
4.
5.
6.
Turn off the computer and disconnect the AC adapter and
all peripherals.
Turn the notebook over so that the rear ports are facing
you and locate the memory module compartment.
Remove the screws that secure the RAM module
compartment cover to the chassis and set it aside. Slide
the cover to the direction of the arrow. Locate the RAM
modules.
Using your fingers or a small screwdriver, press the grips
on the side of the RAM module away from the modules.
The RAM module should pop out slightly.
Gently pull out the RAM modules.
To replace the RAM modules, align the RAM module
connector with the RAM module socket and then press
the RAM module down until it clicks into place.
The Easy to Upgrade HDD Module
Your computer’s hard disk drive is an integrated electronic
drive, commonly referred to as an IDE drive, with a form factor
of 2.5 inches.
Removing and Replacing the Hard Disk Drive
The Notebook’s hard disk is easy to upgrade. To remove the
hard disk drive:
1.
2.
Use a Philip screwdriver to unscrew the screws of the
HDD compartment
Slide the HDD cover in the direction of the arrow as
shown in the illustration.
68