Elitegroup G731 - Manual (Page 81)

time, your CMOS battery may be depleted. Contact your
dealer to change the battery.
Problem:
Solution:
Problem:
Solution:
Problem:
Solution:
Problem:
Solution:
Problem:
Solution:
Problem:
The message: “Invalid system disk,
Replace the disk, and then press any key” appears
during boot.
Check and make sure that you do not have a
non-bootable floppy diskette inserted in your floppy drive.
If your FDD is empty, you may not have an operating
system installed on your drive. Contact technical support
for assistance.
You hear irregular beeps during operation
of the Notebook and the system halts.
The problem is beyond the scope of this
manual. Contact technical support.
An unidentified message is displayed.
Reboot the computer and run the BIOS
system setup. Confirm the Setup parameters. If the same
message is displayed after booting up again, contact
technical support for assistance.
The system cannot access the CD-
ROM/DVD-ROM drive.
Check that a CD is properly inserted in the
drive. Make sure that you are using the correct program
for that kind of CD. For example, the system cannot read
a data CD using an audio program.
You cannot operate the printer.
Check the printer cable connection. Ensure
that the printer power switch is turned on. Confirm that
the printer is on-line.
You can’t save data to disk.
65