beautypg.com

1 calibrator display – Condec 3030 User Manual

Page 8

background image

2.1 Calibrator Display

The Calibrator Display consists of two regions: The menu bar
(located along the bottom of the screen) is used to access a menu
system. The main display (the rest) consists of up to three process
measurement sub-regions. These sub-regions will henceforth be
referred to as the UPPER, MIDDLE and LOWER displays. Figure 3
shows the location of the different display fields while table 3
describes them.

Figure 3

Display

Table 3 Display Functions

No. Name

Description

1

Primary Parameters

Indicates what is being measured.

2

Span Indicator

Indicates the percent of the 4 to 20 mA span.
(For mA and mA Loop functions only)

3

Pressure Units

Indicates one of 17 pressure units available for
display.

4

Units

Indicates the unit of measure for the display.

2.1.1 Main Menu Functionality

There are three options on the Main Menu, CONFIG, {current
display} and MORE. The Main Menu is home for the menu display.

2.1.1.1 Setting the Current Display

The current display is indicated by the center option on the Main
Menu, pressing the F2 key will toggle the current display.

2.1.1.2 Setting Current Display Parameters

To set the parameters of the current display use the CONFIG option
to get to the Display Configuration Menu.

6