Condec 3030 - Manual (Page 35)

For example:
CPRT_COEFB -5.774999E-07 enters -5.774999E-07 as
coefficient B.
CPRT_COEFB?
Returns the number, which was entered for the second
coefficient of the polynomial used in the custom RTD. Using the
example above, CPRT_COEFB? Would return:
-5.774999E-07
CPRT_COEFC
This command is used for entering a custom RTD into the
calibrator. The numeric value entered after the command will be
set as the first coefficient of the polynomial used by the custom
RTD.
For example:
CPRT_COEFC -4.183000E-12 enters -4.183000E-12 as
coefficient C.
CPRT_COEFC?
Returns the number that was entered for the third coefficient of
the polynomial used in the custom RTD. Using the example
above CPRT_COEFC? Would return:
-4.183000E-12
CPRT_R0
Sets the 0° resistance, R0, in the custom RTD. The value must be
entered with a units label. Refer to the Parameter Units table for
assistance.
For example:
CPRT_R0 100 OHM sets R0 to 100 ohms.
CPRT_R0?
Returns the value for the resistance in custom RTD. The above
example would return:
1.000000E+02, OHM
33