Condec 3030 - Manual (Page 25)

To reset the min/max registers simply press the clear key. These
registers are also cleared at power-up or when the configuration is
changed.
10. Factory Setups
The Calibrator is loaded with five factory setups. These setups are
shown below.
Setup 1: The upper display is set to [P1] mode and the middle is set
to mA, lower is off.
Setup 2: The upper display is set to [P2] mode and the middle is set
to mA, lower is off.
Setup 3: The upper display is set to [P1] mode and the middle is set
to [P2], lower is off.
23