Brocade Mobility 7131 Installation Guide - Dependent Mode (Supporting software release 4.1.0.0 and later) - Manual (Page 47)

CE marking and European Economic Area (EEA)
4
Brocade Mobility 7131 Installation Guide - Dependent Mode 39
53-1001567-04
Radio transmitters
This device complies with RSS 210 of Industry & Science Canada. Operation is
subject to the following two conditions: (1) this device may not cause harmful
interference and (2) this device must accept any interference received, including
interference that may cause undesired operation.
To reduce potential radio interference to other users, the antenna type and its gain
should be so chosen that the equivalent isotropically radiated power (EIRP) is not
more than that permitted for successful communication.
This device has been designed to operate with the antennas listed in section 3.3.1
of this installation guide, and having a maximum gain of 13.9 dBi (2.4 GHz) and 13
dBi (5 GHz). Antennas not included in this list or having a gain greater than
13.9 dBi (2.4 GHz) and 13 dBi (5 GHz) are strictly prohibited for use with this
device. The required antenna impedance is
50 ohms.
Label Marking: The Term "IC:" before the radio certification signifies that Industry
Canada technical specifications were met.
CE marking and European Economic Area (EEA)
The use of 2.4GHz RLAN’s, for use through the EEA, have the following restrictions:
• Maximum radiated transmit power of 100 mW EIRP in the frequency range
2.400 -2.4835 GHz.
• France outside usage, the equipment is restricted to 2.400-2.45 GHz
frequency range.
• Italy requires a user license for outside usage.