Brocade Mobility 7131 Installation Guide - Dependent Mode (Supporting software release 4.1.0.0 and later) - Manual (Page 32)

Configuring basic device settings
3
24 Brocade Mobility 7131 Installation Guide - Dependent Mode
53-1001567-04
CAUTION
If the key is not pressed within three seconds after the “Press
esc key to run boot firmware” message displays, the Mobility 7131 will
continue to boot.
6. Type the following at the boot prompt: passwd default
7. Reset the Mobility 7131 by typing the following at the boot prompt: reset system
When the Mobility 7131 re-boots again, the password will return to its default
value of “admin123.” You can now access the Mobility 7131.
Configuring basic device settings
Configure a set of minimum required device settings within the Mobility 7131 Quick
Setup
screen. The values defined within the Quick Setup screen are also
configurable in numerous other locations within the Mobility 7131 menu tree. When
you change the settings in the Quick Setup screen, the values also change within
the screen where these parameters also exist. Additionally, if the values are
updated in these other screens, the values initially set within the Quick Setup
screen will be updated. The following table illustrates the Mobility 7131’s default
configuration.
To define a basic Mobility 7131 configuration:
WAN LAN 1 LAN 2 Access using WAN port
Static IP: 10.1.1.1
Static Mask: 255.0.0.0 DHCP Client
Auto-Update Enabled
Default Gateway
Ethernet Port Enabled Disabled HTTPS, SSH, SNMP, Telnet:
Enabled