Brocade Mobility 7131 Installation Guide - Dependent Mode (Supporting software release 4.1.0.0 and later) - Manual (Page 23)

Mounting the Mobility 7131
2
Brocade Mobility 7131 Installation Guide - Dependent Mode 15
53-1001567-04
CAUTION
Brocade does not recommend mounting the Mobility 7131 directly to
any suspended ceiling tile with a thickness less than 12.7mm (0.5in.)
or a suspended ceiling tile with an unsupported span greater than
660mm (26in.). Brocade strongly recommends fitting the Mobility 7131
with a safety wire suitable for supporting the weight of the device. The
safety wire should be a standard ceiling suspension cable or equivalent
steel wire between 1.59mm (.062in.) and 2.5mm (.10in.)
in diameter.
The mounting hardware required to install the Mobility 7131 above a ceiling
consists of:
• Light pipe
• Badge for light pipe
• Decal for badge
• Safety wire (strongly recommended)
• Security cable (optional)
To install the Mobility 7131 above a ceiling:
1. If possible, remove the adjacent ceiling tile from its frame and place it aside.
2. If required, install a safety wire, between 1.5mm (.06in.) and 2.5mm (.10in.) in
diameter, in the ceiling space.
3. If required, install and attach a security cable to the Mobility 7131’s lock port.
4. Mark a point on the finished side of the tile where the light pipe is to be
located.
5. Create a light pipe path hole in the target position on the ceiling tile.
6. Use a drill to make a hole in the tile the approximate size of the Mobility 7131
LED light pipe.