Brocade Mobility 7131 Installation Guide - Dependent Mode (Supporting software release 4.1.0.0 and later) User Manual
Page 19
Mounting the Mobility 7131
2
Brocade Mobility 7131 Installation Guide - Dependent Mode
11
53-1001567-04
CAUTION
Ensure you are placing the antennas on the correct connectors
(depending on your single or dual-radio model and frequency used) to
ensure the successful operation of the Mobility 7131.
NOTE
It is recommended the Mobility 7131 be mounted with the RJ45 cable
connector oriented upwards or downwards to ensure proper operation.
11. Cable the Mobility 7131 using either Power over Ethernet (PoE) or an approved
line cord and power supply.
For PoE installations, connect an RJ-45 CAT5e (or CAT6) Ethernet cable
between a PoE switch port and the BR7131 GE1/POE port.
For standard power adapter and line cord installations:
a. Connect a RJ-45 CAT5e (or CAT6) Ethernet cable between the network data
supply (host) and the Mobility 7131 GE1/POE or GE2 port.
b. Verify the power adapter is correctly rated according the country of
operation.
c. Connect the power supply line cord to the power adapter.
d. Attach the power adapter cable into the power connector on the Mobility
7131.
e. Attach the power supply line cord to a power supply.
CAUTION
Do not actually connect to the power source until the cabling portion of
the installation is complete.
12. Verify the behavior of the Mobility 7131 LEDs. For more information, see
13. The Mobility 7131 is ready to configure. For information on basic Mobility 7131
device configuration, see