Hardware installation, Precautions, Package contents – Brocade Mobility 7131 Installation Guide - Dependent Mode (Supporting software release 4.1.0.0 and later) User Manual
Page 11: 2 hardware installation, Precautions package contents
Brocade Mobility 7131 Installation Guide - Dependent Mode
3
53-1001567-04
Chapter
2
Hardware Installation
A Mobility 7131 installation includes mounting the Mobility 7131 on a wall, ceiling
T-bar or an above the ceiling orientation, connecting the Mobility 7131 to the
network (LAN or WAN port connection), connecting antennas and applying power.
Installation procedures vary for different environments.
A Mobility 7131 model access point has the following port designations:
•
GE1/POE - LAN port
•
GE2 - WAN Port
Precautions
Before installing the Mobility 7131 verify the following:
•
Do not install in wet or dusty areas without additional protection. Contact a
Brocade representative for more information.
•
Verify the environment has a continuous temperature range between -20° C to
50° C.
Package contents
Check package contents for the correct model Mobility 7131 and applicable
Mobility 7131 accessories. Each available configuration (at a minimum), contains:
•
Mobility 7131 model access point (dependent SKU version)
•
Mobility 7131 Install Guide (this guide)
•
China ROHS Compliance addendum
•
Wall mount screw and anchor kit
•
Accessories Bag (4 rubber feet and a LED light pipe and badge with label for
above the ceiling installations)
Contact the Brocade Support Center to report missing or improperly functioning
items.