Brocade Mobility 7131 Installation Guide - Dependent Mode (Supporting software release 4.1.0.0 and later) - Manual (Page 14)

Mounting the Mobility 7131
2
6 Brocade Mobility 7131 Installation Guide - Dependent Mode
53-1001567-04
The 5 GHz antenna suite includes the following models:
For detailed specifications on the antennas available to the Mobility 7131, refer to
the Mobility 7131 Product Reference Guide or the Enterprise Wireless LAN Antenna
Specification Guide. Both guides are available at
http://www.brocade.com/support .
Mounting the Mobility 7131
The Mobility 7131 can attach to a wall, mount under a suspended T-Bar or above a
ceiling (plenum or attic). Choose one of the following mounting options based on
the physical environment of the coverage area. Do not mount the Mobility 7131 in a
location that has not been approved in a site survey.
Wall mounting
Wall mounting requires hanging the Mobility 7131 along its width (or length) using
the pair of slots on the bottom of the unit and using the Mobility 7131 mounting
template (on the next page) for the screws.
CAUTION
A Mobility 7131 should be wall mounted to concrete or
plaster-wall-board (dry wall) only. Do not wall mount a Mobility 7131 to
combustible surfaces.
Part Number Antenna Type Nominal Net Gain (dBi)
ML-5299-WPNA1-01R Panel Antenna 13.0
ML-5299-HPA1-01R Wide-Band Omni-Directional
Antenna 5.0
ML-2452-APA2-01 Dual-Band 4.0
ML-2452-PTA2M3X3-2 Facade with 6 Element
Antenna Module 2.0
ML-2452-PTA3M3-036 3 Port MIMO Antenna 3.0