Step 15, Step 16, Step 17 – Anthro Elevate Original Corner Assembly Instructions User Manual
Page 8
8
Questions? Call us at
800.325.3841 or visit anthro.com. We’re happy to walk you through the assembly!
STEP 15
Home the legs
Press down button until the table reaches its lowest point and stops moving. Release the button for 1-2 seconds. Press
down button again for 3-5 seconds and you will see the table home itself.
Press up button until the table tops at the highest point and hold for 3-5 seconds. Press the down button for 2-3
seconds, then the up button again until it tops at the highest point and hold again for 3-5 seconds. (The goal is to have
the table hold at it’s highest point twice.)
If the legs ever fail to function properly, unplug the power cord, wait 10 seconds, plug the power cord back in and repeat
the above steps.
Legs must also be homed any time that power is disconnected from the legs.
If the legs are not homed at both the top and the bottom, the table will only move at half its normal speed.
STEP 16
Add Accessories and Install Your Equipment
Now add your Anthro accessories and install your equipment.
A word of caution: the height range of Elevate may be longer than the cords on your equipment. Equipment that is
mounted in a SideRack w/Caster or Equipment Shelf, for example, will not move up and down with the table. Raise and
lower the table to its highest and lowest positions when all equipment is installed to make sure that the cords are long
enough. Double-check that all the table's cords and cables reach comfortably through the table's entire range of motion.
STEP 17
Insert Grommets and End Caps
Slip the grommet covers into place. (Gently
whack them with the mallet if they’re stubborn.)
Pop end caps into the cross bars and base tubes.
Use the mallet to set them into place.
Congratulations! Your assembly is complete!
End Cap
Grommet
*300-5596-00*
300-5596-00
Warranty:
Elevate Original Corner has a Lifetime Warranty against manufacturing defects, two years for the electrical system. Cords and plugs
are not warranted.
Notices:
Technology Furniture and Elevate are trademarks of Anthro Corporation. Anthro reserves the right to modify the design and
specifications without prior notice.