Anthro Elevate Original Corner Assembly Instructions - Manual (Page 5)

Elevate TM Original Corner Assembly Instructions 5
STEP 9
Install the Outside Leg Assemblies
ƒ Align one Outside Leg Assembly with the hole array on
the Top Assembly. Make sure that the Leg Gusset is to the
outside of the table and the cable is to the inside of the
table. Also verify that the slot on the leg lines up with the
hole in the base tube. (See the image on Step 6.)
ƒ Tilt this Outside leg Assembly into place with the top of
its Cap Screws seated into the notches on the shelf. But
don't attach with wood screws...not yet. [Image A]
ƒ Loosely attach the Cross Tubes into this Leg Assembly
using 4" Cap Screws and Curved Washers. Make sure that
the curves at the ends of the Cross Tubes line up with the
round Base Tube. [Image B]
ƒ Repeat for the other outside leg.
STEP 8
Assemble the Corner Base Assembly
ƒ Attach a pair of Cross Tubes to one side of the Corner
Shelf Cap using two Flat Washers and two 3.5" Bolts.
Tighten the fasteners all the way.
ƒ Repeat for the second pair of Cross Tubes.
ƒ Align the Leg Plate over the Corner Shelf Cap and slide
into place. Using a 7/16" socket, open end wrench,
adjustable wrench, or the Anthro three-way wrench,
tighten four Lock Nuts onto the threaded pins.
ƒ Secure the side of the Leg Plate to the Corner Shelf
Cap using 1/2" Button Head Cap Screws. Drive the
screws from the outside in.
ƒ Lift this Corner Base Assembly over the center legs and
seat them in place, but don’t attach them!
3.5" Bolt
325-5194-00
Flat Washer
325-5379-00
1/2" Button Head Cap Screw
325-5003-00
Lock Nut
325-5259-00
A
4" Cap Screw
325-5166-00
Curved Washer
225-3522-00
B