PreSonus FireStudio Lightpipe - Manual (Page 28)

CONTROLS & CONNECTIONS
25 | PreSonus 2008
Master Output Section
 Master Output Fader Changes the Selected Output’s Audio Level
Move the Master Fader up and down to increase and decrease the level of the
selected output’s audio.
The amount of boost or attenuation, measured in decibels, is displayed below the
Channel Fader. The range is from –∞ to 0 dB.
Two virtual LED meters to the right of the Master Fader display the prefader
levels of the audio signal.
The peak value in dBFS of the channel’s audio is displayed directly above the
Master Output’s virtual LED meter.
NOTE: If the peak values display “CLIP,” then your mixer channels and/or your
DAW playback levels should be reduced. The clip indicators clear when
the mouse pointer hovers over them.
 Master Mute and Solo Clear
Clears All Active Channel Mutes or Solos
The Master Mute and Solo Clear buttons are only active when a channel’s mute
or solo button is active.
Mixer Section
 Channel Pan Sliders
Moves the Channel’s Audio Left/Right in the Stereo Field
Double-clicking the slider returns the pan to center.
 Link Buttons Links the Adjacent Channels as a Stereo Pair
When channels are linked, changing either channel’s level changes both channels’
levels, and the signals are panned hard left and right.
 Channel Faders
Changes the Channel’s Audio Level
Move the Channel fader up and down to increase and decrease the channel’s
audio level.
The amount of boost or attenuation, measured in decibels, is displayed below the
Channel Fader. The range is from –∞ to +6 dB.
A virtual LED meter to the right of each fader displays the postfader level of the
channel’s audio.
The peak value, in dBFS, of the channel’s audio level is displayed directly above
each channel’s virtual LED meter.