Cut back 0.750, Special hookups – MAHLE RTI VCX-1 User Manual
Page 9
Page 8
PINCH
HOSE
HOSE
PINCH
Overflow
Radiator
Hose
Cut back
0.750
Special Hookups
Seal Tight Radiator
1.
Insert the Adapter Hose into the end of the Cone Plug Adapter.
2.
Place the Cone Adapter snugly into the radiator, coiling the excess length of Adapter Hose
at the bottom.
3.
Follow the Empty Radiator procedure steps 1-9.
More Effective Setup for Empty Radiator
During the Empty Radiator procedure clamp off the upper
radiator hose and follow steps 1-9 of the Empty Radiator
section.
Adapter Seal
1.
In some cases it may be necessary to cut up to 0.75" off of the Cone Plug Adapter. This is
only necessary when a tight seal can not be created due to bottoming out against the inside
of a shallow radiator neck.
2.
Take care to cut a clean edge free of loose debris.
See also other documents in the category MAHLE RTI Accessories for air:
- NTO-200 (REV A) (16 pages)
- NTO-200 (7 pages)
- NTF-15H (1 page)
- NTF-15H (11 pages)
- NTF-230 (13 pages)
- NTF-230 (Rev B) (11 pages)
- NTF-15 (10 pages)
- NTF-15 (11 pages)
- NTF-515 (Rev A) (14 pages)
- ATX-2 (Rev B) (15 pages)
- ATX-2 (Rev B) (17 pages)
- ATX-2 (Rev C) (15 pages)
- ATX-2 (Rev D) (17 pages)
- ATX-2 (15 pages)
- ATX-2 (17 pages)
- ATX-2 (18 pages)
- ATX-2 (Rev A) (17 pages)
- PSX-2 (2 pages)
- ATX-3 (22 pages)
- MCX-1 (Rev A) (16 pages)
- MCX-1 (Rev D) (18 pages)
- MCX-1 (Rev E) (18 pages)
- MCX-2 (Rev A) (18 pages)
- MCX-2 (Rev B) (20 pages)
- MCX-2 (Rev C) (20 pages)
- MCX-2 (Rev D) (20 pages)
- MCX-2 (Rev E) (20 pages)
- MCX-2 (18 pages)
- MCX-2 (Rev F) (21 pages)
- MCX-2 (Rev F) (20 pages)
- MCX-2 (Rev G) (20 pages)
- MCX-2F (Rev A) (21 pages)
- MCX-2F (Rev C) (21 pages)
- MCX-2F (21 pages)
- MCX-2F (Rev D) (21 pages)
- MCX-2HD (20 pages)
- VCX-1 (17 pages)
- VCX-4 (17 pages)
- PSX-3 (1 page)
- DFX-1 (1 page)
- BFX-2 (12 pages)
- BFX-2 (13 pages)
- DCS-1 (2 pages)
- ELF-1 (14 pages)