MAHLE RTI PSX-2A - Manual

Page 1 of 2
REMOVE USED FLUID
FROM RESERVOIR
ADD NEW FLUID
TO RESERVOIR
SERVICE HOSE
CAUTION
The PSX-2 is designed to exchange power steering fluid
and approved power steering flush chemicals.
Using the PSX-2 for brake fluid and other liquids may
damage the pump seals and void the warranty
PSX-2
OPERATION INSTRUCTIONS
EXCHANGE
1. Verify that there is enough fluid in the New Fluid Tank
and sufficient space in the Used Fluid Tank for the
exchange procedure. The vehicle engine must be off.
2. Remove the Power Steering Fluid Reservoir Cover and
submerge Service Hose into the reservoir.
3. Remove the used fluid from the Reservoir by pressing
the rear of the switch on the control wand.
4. Refill the Reservoir by pressing the front of the switch
on the control wand.
Suggestion: Fill new fluid level slightly above steering
rack return line.
5. Start the vehicle and turn the steering wheel all the way
clockwise and then all the way counter-clockwise (lock
to lock).
6. Turn the vehicle engine off.
7. Repeat steps 3 through 6 until the desired level of fluid
exchange is achieved.
Caution: Do not allow Used Tank to overfill
REPLACEMENT PARTS
Pump 320-80016-00
New Fluid Tank 315-80004-00
Used Fluid Tank 315-80005-00
Hose Cap 028-80250-18
Switch 024-80088-00
Technical Support: 800-468-2321 035-80988-00
RTI Technologies, Inc. - 4075 East Market Street - York - PA 17402 - USA