Yokogawa Standalone MW100 - Manual (Page 4)

4
1.2.1. Operation Guide
Set up MW100,
Install MX118
Connect serial cable
Connect power cable
Start configuration
tool
Set slot width
Set bit rate
Set msg. format/ ID
Enter channel
settings
Send settings
Place MX118 in
Measurement mode
Connect to CAN
bus network
System configuration
Set up MW100
Enter serial comm.
settings
Op. on PC Op. on Main Unit
Section.1.6,
Launching/Exiting
Setting Software
Sec. 2.2, Setting Up Serial
Communications
Sec.2.3, CAN Comm
Settings
（common setting screen）
Sec. 2.4, Setting Message
ID
（Message Screen）
Sec.2.3, CAN Comm.
Settings
（common setting screen）
Sec. 2.5, Channel Settings
（channel screen）
Section 2.1, Connecting
the MX118
Sec. 2.7, Sending/Receiving
Settings
Sec., 2.12, Switching to
Measurement mode