Yokogawa Standalone MW100 - Manual (Page 15)

15
2.4. Setting the Message ID (Message Screen)
You can enter settings related to the CAN message ID.
If the Message screen is not displayed, click the Message tab.
1. Select a message number format of OFF, Standard, or Extended.
2. Enter the CAN message ID to be measured under BASE-ID (or BASE-ID and EXT-ID) using
hexadecimal notation.
Explanation
Format
You can set the format for the CAN message to be measured. Select OFF for the format of message
numbers you will not use. The format of the message number selected under Message No. in the
Channel screen cannot be turned OFF.
Standard: Select when receiving standard format CAN messages.
Extended: Select when receiving extended format CAN messages.
ID
For standard format, the available setting range is 0 to 7FF (11-bit hexadecimal).
For extended format, the available setting range is 0 to 1FFFFFFF (29-bit hexadecimal), but with this
software the 11-bit base ID portion is set separately from the 18-bit extended ID portion.
BASE-ID
You can input the BASE-ID if Standard or Extended is selected for the format.
You can enter an 11-bit standard format ID, or an 11-bit extended format base ID in hexadecimal
notation. The available setting range is 0 to 7FF (11 bit).
EXT-ID
You can input the EXT-ID if Extended is selected for the format.
You can enter an 18-bit extended format extended ID.
The available setting range is 0 to 3FFFF (18 bit).
Format EXT-ID BASE-ID