Yokogawa Standalone MW100 - Manual (Page 9)

9/17
3.3.Setting Up Filters
You can set filters for CAN measurement channels. The burnout and reference junction compensation
settings are ignored for CAN bus modules.
From the top screen, click Channel Settings > Filter,Burnout,RJC setting under the Top item.
Setting the Filter Coefficient
Select a coefficient from the Filter Coefficient list.
For noise sources other than power supply noise, the MW100 Data Acquisition Unit is equipped with a
first-order lag filter having output characteristics relative to step input. For the filter setting, the time constant
is determined by selecting filter coefficient N for the measurement interval.
Click the Apply button. This enables the settings changes.
Note
For filter coefficients, see section 2.10, "Measures against Noise on the MW100 Data Acquisition Unit" in the
MW100 Data Acquisition Unit User’s Manual (IM MW100-01E).