Yokogawa Standalone MW100 - Manual (Page 7)

7/17
3.2.Setting Up Measurement Channels
You can set the input type, range, span, computations, difference input, and scale.
Setting the Input Range
(1). From the top screen, click Channel Settings > AI/DI Channel settings under the Top item.
(2). Select the channel group you wish to set from the Channel list box.
Setting the Input Mode
Select an input mode of COM or SKIP from the Mode list.
Setting the Measurement Range
Only the measurement range of CAN can be selected from the Range list.
Setting the Measurement Span
Determines the actual measuring range from the measurable range.
Enter the lower or upper limit of Span in the Lower limit value or Upper limit value box under Span. The
available setting range is -30000–30000.
Setting the Scaling
Set these items when linearly scaling the measured values.
(1). Select SCALE in the Computation box.
(2). Enter the lower or upper limit of scale in the Lower limit value or Upper limit value box under Scale. The
available setting range is -30000–30000.
(3). Select the decimal point position from the Point list box under Scale.
(4). Enter the scale conversion value in the Units box.
Setting Difference Input
(1). Select DELTA in the Computation box.
(2). Enter the reference channel number in the Reference box.
Click the Apply button. This enables the settings changes.