Yokogawa Standalone MW100 User Manual
Page 13
13/17
6. CAN Bus Module (MX118-CAN-M30) Specifications
6.1.Model Name
Model Name
Description
Max. Number of
Channels
Min. Sampling
Interval
Slot Width
MX118-CAN-M30
CAN Bus Data Acquisition
Module
30 ch
10 ms
1–3
6.2.Module Specifications
Number of Channels: 30 ch/module
No. of messages (ID): 30
Sampling interval: 10 ms–60 s
Max. no. of installed modules: Differs by slot width setting (no. of ch used per module)
Slot Width Setting
Max. No. of Ch Used
Max. no. of Modules (per System)
1 10
ch
6
2 20
ch
5
3 30
ch
4
Multi-interval: Allowed. However, if the slot width is 2 or 3, a separate measurement interval cannot be set
for the real and virtual instances of the same module.
Mode switching: Switch between Setting and Measurement modes with hardware dip switch.
Setting mode: CAN bus settings can be entered externally from a PC using a SERIAL (connector).
Measurement mode: CAN bus data can be captured and transferred to the MW100 using a CAN
(connector).
Data range: -30000–30000 (range of data that can be transferred to the MW100)
Set using the upper/lower limit of span.
Scaling computation: The following scaling computation is carried out inside the module.
SpanMin
SpanMin
SpanMax
ValueMin
ValueMax
ValueMin
InputValue
+
−
−
−
)
(
Input Value
: Input CAN bus data (max. 64 bit data)
Value Max
: Upper limit of CAN bus data set by user
Value Min
: Lower limit of CAN bus data set by user
Span Max
: Upper limit of span set by user
Span Min
: Lower limit of span set by user