Yokogawa Standalone MW100 - Manual (Page 16)

16/17
Dip Switch Settings
-:Don’t care
Note
Number of channels is limited to 10 per unit when the sampling interval is 10 ms. (MW100 standard
specifications)
The CAN bus module’s physical slot width is always 1, but set an occupied slot width of 1-3 depending on the
number of channels used.
Dip Switch No. 1 2 3 4 5 6 7 8
Baud rate
57600bps
ON OFF OFF OFF OFF OFF OFF -
Setting mode
Baud rate
9600bps
ON ON
OFF OFF OFF OFF OFF -
Measurement mode OFF OFF OFF OFF OFF OFF OFF -
ON - - - - - - -
ON
CAN bus comm.
terminator OFF - - - - - - - OFF
ON
1 2 3 4 5 6 7