Yokogawa Standalone MW100 - Manual (Page 10)

10/17
4. Communication Commands
4.1.Setting the Input Range
When setting p2=SKIP
SR p1,p2
When p2=COM
When p6=OFF
SR p1,p2,p3,p4,p5,p6
When p6=DELTA
SR p1,p2,p3,p4,p5,p6,p7
When p6=SCALE
SR p1,p2,p3,p4,p5,p6,p7,p8,p9,p10
When Setting Channels to SKIP
Syntax SR p1,p2
p1 Channel range (001–060)
p2 Input mode (SKIP)
Query SR[p1]?
Example) Set channel 1 to SKIP.
SR 001,SKIP
Explanation)
Channels set to SKIP are not measured.
Specify measurement channels on p1.
When Setting Channels to COM
When no computation performed
Syntax SR p1,p2,p3,p4,p5,p6
p1 Channel range (001–060)
p2 Input mode (COM)
p3 Measurement range (CAN)
p4 Lower limit of span (-30000–30000)
p5 Upper limit of span (-30000–30000)
p6 Computation mode (OFF)
Query SR[ p1]?
Example) Set the input type for channels 1–10 to COM(CAN), the lower limit
span to 0, and the upper limit of span to 10000.
SR 01-10,COM,CAN,0,10000,OFF
Explanation)
Specify measurement channels on p1.