Yokogawa EJA115 - Manual (Page 40)

IM 01C22T03-00E A-2
APPENDIX 1. LIST OF PARAMETERS FOR EACH BLOCK OF THE EJA
Index
37
Parameter
Message
Write
Mode
AUTO
Initial Value
Space
Description
User definable MESSAGE (a string) to describe the device
within the application or in the plant.
50 Set Address AUTO 0 For Bus address set up; refer to 5.3 Bus Address set up.
41 HW Write Protection -- Off Not used for EJA
40 PROFIBUS Ident Number AUTO Manufacture
Specific
Each PROFIBUS-PA device shall have an Ident_Number
provided by the PNO.
Manufacture specific
Profile specific
38 Installation date AUTO Space Date of installation of the device.
49 Software Description -- Uncertain Yokogawa internal use.
TA0101-02.EPS
36 Descriptor AUTO Space
User definition text (a string) to describe the device within the
application.
34 Write Locking AUTO Off
If set, no writes from anywhere are allowed, except to clear
WRITE_LOCKING.
on/off
35 Factory Reset AUTO Factory Reset
Allows a manual restart to be initiated.
Factory Reset: Resetting device for default values.
The bus address setting remains the
same.
Warm Start: Warm start of the device. All
parameterization remains unchanged.
Reset Address to '126': Reset the bus address only.