Yokogawa EJA115 - Manual (Page 20)

IM 01C22T03-00E 4-5
4. GETTING STARTED
COMM DTM Configuration
In the Network Configurator window, click [Action] →
[COMM DTM Configuration].
Select the baud rate for the DP/PA coupler (or link).
Click [Defaults] to change the data to the default
setting, or enter the desired bus parameters.
Click [OK]
IMPORTANT
When comm DTM is connected to the
PROFIBUS network with class I master running,
set the same busparameters of class I master.
Figure 4.7 COMM DTM Configuration
Exit Function Configuration-DTM Works.
Click [ ×]
When queried “Do you want to exit DTM Works?”,
click [Yes].
[Yes] .
Figure 4.8 Exit Function Configuration
Running Scan List
In the Network Configurator window, click [Action] →
[Scan List] → [Scan].
When queried “DTM is disconnected. Do you want to
connect now?”, click [Yes].
Figure 4.9 Setup Scan List
Confirm Address No.
Confirm the address no. and then click [Close].
Figure 4.10 Confirm Address No.
From the Network Configurator window, click [File]
→ [Save Configuration].
Click [File] → [Exit].