Progressive International Electronics PCXZ - Manual (Page 9)

Progressive International Electronics PCXZ
Version 4.2/April 2005 Page 1
PCXZinstall
System Installation
System Installation Warnings
Safety hazards are inherent with all electrical equipment. Standard precautions must be taken at all times during installation and
operation of the PCXZ systems. In addition to normal electrical precautions, the following points should be noted during installation.
C Installation must comply with National Electrical Code, as well as Federal, State/Provincial,
Local, and all applicable codes.
C High voltages are present in the PCXZ components, as well as the equipment to which it is
attaching. To prevent personal injury or equipment damage, disconnect all power before
proceeding with installation.
C PCXZ equipment must be installed in nonvolatile, noncombustible, nonexplosive areas. The
main box must be protected from severe vibration, extreme temperatures and excessive
humidity.
C All PCXZ peripheral equipment must be installed in nonhazardous locations and must be UL-
listed, using standard RS232 communication.
For Use in USA
Installation of the PCXZ fuel control system must comply with the requirements of the National
Electrical Code (NFPA 70), the Automotive and Marine Station Code (NFPA 30A), and all Federal,
State, Local, and applicable safety codes.
For Use in Canada
Installation of the PCXZ fuel control system must comply with the requirements of the Canadian
Electrical Code, the Flammable and Combustible Liquid Code, and all Federal, Provincial, State,
Local, and applicable safety codes.
The installation of the systems covered by this manual in conjunction with equipment not UL Listed has not been evaluated by the
Underwriters Laboratories and is outside the intended use of this equipment. Warning: All dispensing equipment discussed in this
manual is not UL Listed and the combination has not been evaluated by Underwriters Laboratories.