Progressive International Electronics PCXZ - Manual (Page 22)

Progressive International Electronics PCXZ
Version 4.2/April 2005 Page 14
PCXZinstall
For Dispensers Using Model 67 or 67B DBox
The 67 and 67B DBoxes are similar. Be sure to determine model number from
nameplate before attempting to connect to this device or damage may occur.
2. Connect wires to the 67 connection box according to Tokheim’s instructions. Program the
dispensers as though they were connected to a MIMS-IV.
3. Locate dispenser connection cable (with DB9S hooded connector on one end and a round
connector on the other end). Connect the dispenser connection cable to the connector on
the Tokheim configuration box.
Screw-lock this connector to the box with screws provided.
4. Locate the other end of the dispenser connection cable. Connect the round connector from
the PCXZ cable to the cable from the 67 DBox.
Cables must be screw-locked together. The connection must be in a sheltered
environment, protected from harsh elements such as water, extreme heat or cold,
etc.
5. If configuring for liter units, ensure that pump jumpers DA and DB at position JP1 are
installed. See Diagram: PCXZ Connector/Jumper Layout.