SaltDogg TGS06 Salt Spreader - Manual (Page 3)

3
TM
27
38
37
42
43
27
43
44
Fig. 2A
Fig. 2B
2. Assemble and install Hitch Receiver to Vehicle
Option A (hitch assembly) suggested
Refer to Fig. 2A
• Insert hitch receiver 27 into hitch of vehicle as shown with
slots in vertical tube portion pointing towards the ground.
Select one of the three mounting holes, insuring opening in
vertical tube is not obstructed by bumper.
• Insert hitch pin 37 and secure with cotter pin 38.
• This mounting hole location may change later in the
assembly.
Option B (bumper assembly) Refer to Fig. 2B
• Align hitch receiver 27 with precut hole (ball mount hole)
on factory bumper with slots in vertical tube portion point-
ing towards the ground. Slide vehicle tube as close to bum-
per as possible.
Note: On some vehicles the bumper may have a plastic liner
covering the bumper and ball mount hole. In this situation,
the plastic liner may need to be cut to gain access to ball
mount hole.
• Insert hardware, (1) 5/8"-11 x 5" bolt 42, (2) 5/8" washers 43,
and (1) 5/8"-11 nut 44.
• Hand tighten hardware at this time.