SaltDogg SHPE1500 Series Electric Drive Poly Hopper Spreader v.2 - Manual

1
Average Material Weights
Materials to use Weight (pounds per cubic yard)
Fine Salt-Dry 2,250
Coarse Salt-Dry 1,431
Sand/Salt up to 50/50 Mix-Dry 2,700
Note: To calculate the total spreader weight (including ice
control material), add the empty spreader weight plus the ice
control material and spreader accessories.
Safety Precautions
1. Read the entire Installation Instructions before
operating this spreader.
2. Read all safety decals on the spreader before
operating.
3. Check to make sure all safety guards are securely
mounted into place before operating this spreader.
4. Verify that all personnel are clear of the spread-
er spray area before starting or operating this
spreader.
5. Do not over-load your vehicle beyond payload lim-
its. If there are any questions, contact the vehicle
manufacturer.
6. Do not adjust, clean, lubricate or unclog material
jambs without first turning off the spreader.
7. Do not climb on or in the spreader during operation.
8. Do not ride on the spreader while the vehicle is
in motion.
9. Make sure the spreader is securely fastened to the
vehicle in accordance with this manual.
10. Do not operate a spreader that is in need of main-
tenance or repairs.
11. Always disconnect the battery before removing or
replacing electrical components.
Installation Instructions
—continued inside
SHPE1500, SHPE1500RED,
SHPE1500YEL Series SaltDogg
®
Electric Drive Poly Hopper Spreader
1.5 cubic yards
Serial Number 6500 and higher.
Protected by U.S. patent D520 524; other patents pending
Table of Contents
General Information .........................................................1
Safety Precautions ............................................................1
Installation Instructions .............................................. 2-3
Spreader Operation ...................................................... 3-4
Spreader Maintenance .....................................................4
Repair Parts & Drawings ............................................. 5-8
Warranty Information ......................................................8
General Information
Spreader model numbers:
• SHPE1500 - spreader with standard chute
• SHPE1500X - spreader with extended chute
Overall Length: 92-1/8"
Overall Width: 50-1/2"
Overall Height (installed): 37-1/2"
Empty Weight: 410 lbs.
Capacity Struck: 1.5 cu. yd.
Vehicle Requirements
• 3/4 or 1 ton Pickup Truck above 8,500 lbs. GVWR.
• 135 amp or higher alternator is recommended.
CAUTION
Do not overload vehicle beyond the vehicle’s GVWR
or GAWR. Check vehicle's load rating certification
sticker for maximum vehicle capacity.
WARNING
Observe the following Safety Precautions before, during and
after operating this spreader. By following these precautions
and common sense, possible injury to persons and potential
damage to this machine may be avoided.
9049 Tyler Blvd. • Mentor, Ohio 44060
Phone (440) 974-8888 • Fax (800) 841-8003
www.saltdogg.com