SaltDogg 92440SSA Series Under Tailgate Spreader - Manual

1
TM
Instruction Manual
Under Tailgate Spreaders
Electric 12 VDC
92440SSA
Under TailgaTe Spreader WarranTy
This warranty replaces all previous warranties and no employee
of this company is authorized to extend any additional warranties,
or agreements, or implications not explicitly covered herein.
Buyers Products Company warrants all parts of the product to
be free from defects in material and workmanship for a period of
(1) one year from the date of original installation. Parts must be
properly installed and used under normal conditions. Normal wear
is excluded.
Any part which has been altered, including modification, misuse,
accident, or lack of maintenance will not be considered under this
warranty. The sole responsibility of Buyers Products Company
under this warranty is limited to repairing or replacing any
part(s) which are returned, prepaid, 30 days after such defect is
discovered, and returned part(s) are found to be defective by Buyers
Products Company.
Authorization from Buyers Products Company must be
obtained before returning any part. The following information
must accompany defective parts returned to Buyers Products
Company: RMA#, spreader model, serial number, date installed,
and distributor from whom it was purchased. Buyers Products
Company shall not be liable for damage arising out of failure of
any unit to operate properly, or failure, or delay in work, or for any
consequential damages. No charges for transportation or labor
performed on any part will be allowed under this warranty.
Table of Contents
Warranty Information ............................................... 1
Spreader Installation Instructions ........................ 1,2
Spreader Installation Drawing ................................. 2
Spinner Assembly Instructions ..............................3,4
Spinner Assembly Drawing ...................................3,4
Operating Instructions ...........................................5,6
Recommended Maintenance .................................... 6
Parts list .................................................................... 7
Parts List: Hardware Box ......................................... 8
Spinner Components Drawing ................................. 8
installation instructions
NOTE: The left and right end plates may, on
occasion, get bent through improper handling
during shipment or storage. If this should hap-
pen, square and true the left and right end plates
before installation.
1. aligning the spreader:
A. Position the spreader with the truck such that
the auger gear motor is located on the right side of
the truck (passenger side).
B. Lift the spreader up and under the dump body
tailgate, positioning the spreader forward as close
as possible to the dump body. The tailgate of the
dump body should lay down horizontally over the
spreader.
C. Support the spreader solidly and securely when
positioning for mounting.
2. attach mounting brackets (See Fig. 1.)
A. Attach a quick detach plate, (1) to both sides of
the spreader frame using hinge pins (2) and a hair-
pin cotter pins (5).
B. Position the (2) quick detach plates over the
dump body rub rails and flush with rear edge of
dump body.
C. Weld the quick detach plates to the dump body
rub rails. Weld the plates continuously around 3
sides of each plate. Do not weld along the edge of
the plates next to the attachment pin.
—continued inside
9049 Tyler Blvd. • Mentor, Ohio 44060
Phone (440) 974-8888 • Fax (440) 974-0165
Toll-Free Fax 800-841-8003 • saltdogg.com