SaltDogg SHPE4000 Series Electric Drive Poly Hopper Spreader - Manual

9
TM
ATTACH
LIFTING
HOOKS HERE
9049 Tyler Blvd. • Mentor, Ohio 44060
Phone (440) 974-8888 • Fax (440) 974-0165
Toll-Free Fax 800-841-8003 • saltdogg.com
Installation Instructions
SaltDogg ® Spreader Hopper Poly Eletricial
4.0 cubic yards
—continued inside
CAUTION
Do not overload vehicle beyond the vehicle’s GVWR or GAWR.
Check vehicle’s load rating certification sticker for maximum
vehicle capacity.
Table of Contents
General Information ........................................1
Safety Precautions ...........................................1
Warranty Information ......................................2
Installation Instructions ............................. 2-4
Spreader Operation ..........................................5
Spreader Maintenance ....................................5
Repair Parts & Drawings ...........................6-10
General Information
Overall Length: 107.62 inches
Overall Width: 74 inches
Overall Height: 44 inches
Empty Weight: 774 lbs
Capacity Struck: 4.0 cu. yd.
Vehicle Requirements
Trucks with GVWR 15,000 to 26,000 lbs.
135 AMP or higher alternator is recommended.
Average Material Weights
Materials to use Weight (pounds per cubic yard)
Fine Salt-Dry 2,250
Coarse Salt-Dry 1,431
Sand Coarse-Dry 2,565
Note: To calculate the total spreader weight (including ice
control material), add the empty spreader weight plus the ice
control material and spreader accessories.
WARNING
Observe the following Safety Precautions before, during and
after operating this spreader. By following these precautions
and common sense, possible injury to persons and potential
damage to this machine may be avoided.
Fig. 1
Safety Precautions
1. Read this entire Owners Manual before operating this spreader.
2. Read all safety decals on the spreader before operating.
3. Check to make sure all safety guards are securely
mounted into place before operating this spreader.
4. Verify that all personnel are clear of the spreader spray
area before starting or operating this spreader.
5. Do not over-load your vehicle beyond payload limits. If
there are any questions, contact the vehicle manufacturer.
6. Do not adjust, clean, lubricate or unclog material jambs
without first turning off the spreader.
7. Do not climb on or in the spreader during operation. Do not
ride on the spreader while the vehicle is in motion.
8. Make sure the spreader is securely fastened to the vehicle
in accordance with this manual.
9. Do not operate a spreader that is in need of maintenance
or repairs.
10. Always disconnect the battery before removing or
replacing electrical components.
Installation Instructions
1. Mounting the Spreader onto the Vehicle:
A. Remove the tailgate from the vehicle (if equipped) as well
as any other object which will interfere with the spreader.
B. Check truck’s bed for all kinds of sharp debris or foreign
objects. They can cut and seriously damage poly hopper.
C. Next, set the spreader in the truck body. Use openings in
both inverted vee brackets to lift the spreader (Fig.1).