SaltDogg LS1 Liquid Spray System - Manual

1
TM
9049 Tyler Blvd. • Mentor, Ohio 44060
Phone (440) 974-8888 • Fax (440) 974-0165
Toll-Free Fax 800-841-8003 • saltdogg.com
Installation & Operator’s Manual
LS1 Liquid Spray System
LS1 shown mounted on 1400500SSH
Installation Instructions
1. Position pump enclosure bracket
(#3028485) (see fig. 1) and pump enclosure
(#WSE39) (see fig. 2) at left rear corner of
hopper spreader, (see figs. 1 & 2). Make sure
pump enclosure and bracket do
not interfere with operation of other
accessories such as the feedgate
lever, engine hood, etc.
2. Weld pump enclosure
bracket (#3028485) in place.
3. Position reservoir (#WSE26),
tie bar (#3008589) (see figs.
1 & 2) and mounting brackets
(#3009715) on left side of hopper
between side gussets. Make sure reservoir
is positioned for adequate plumbing
clearance and to remove filler/
breather cap. Check hopper size and style.
Tank may not fit on some hoppers.
4. Mark selected mounting locations, remove
reservoir and weld brackets in place.
5. Install reservoir on mounting brackets. Use
two (#1496505) (see fig. 2) 1-3/4" x 5" ratchet
tie downs to secure reservoir using provided
tie down slots and hooks in mounting
brackets.
6. Plumb: Reservoir, ball valve, filter, pump
encloser, and spray nozzles according to
plumbing schematic using supplied fittings,
hose, and hose clamps. Do not use Teflon
tape on threads. Use liquid thread sealant.
(see fig. 5, 6, & 7).
7. Two 11/16" diameter holes are prepunched
on the backside of Buyers Products mid-size
spreaders for installation of two liquid spray
nozzles. They are located 4" down from the
back wall of the spinner chute and are spaced
7-3/4" apart on center (as shown in reference
drawing). Installation on different brands
of spreaders may require different nozzle
locations. (see fig. 3).
—continued inside