American Dynamics Tyco 8 User Manual
Page 16
Installing IP SDU8 with an Indoor Hardmount
3-6
Installation Guide
Figure 3-8 Inserting the IP SDU8 into ceiling
21 Turn each of the two locking screws clockwise to fully extend the "swing out" mounting clips
and to seat them tightly against the top surface of the ceiling.
Figure 3-9 Securing the IP SDU8 with the Mounting clips
22 Apply power to dome.
When power is applied, the dome checks its functionality by performing a homing routine
during which the camera pans and then either goes to the start point of the "apple peel" pattern,
or if powered up once before, to the last position in memory. Once the camera stops, the
camera is online and is ready to be controlled.
Green, Orange, and Yellow LEDs will light in various patterns to indicate status. Typically, you
do not need to view these LEDs unless a failure occurs during or after the routine. See
Diagnostic LED Status Descriptions on page 7-1 for an explanation of the LED patterns.
Once the homing routine completes, affix the bubble to the dome as described in
Attaching the Bubble to the IP SDU8 Unit
(EQ 1)
Procedure 3-2 describes how to attach the bubble assembly to the installed IP SDU8 unit.
Procedure 3-2 Attaching the Bubble to the IP SDU8 Unit
1 Remove the bubble assembly from the package and ensure the bubble is clean and free of
debris.